59
9.17. Tips in installing the Connecting cord for power source
Move the Massage mechanism block to the highest position.
* After installing the Connecting cord for power source, be sure to move the Massage mechanism block up an down pushing the
and buttons on the Controller by Secret mode (CE) so as to check whether each Connecting cords do not touch Belts or the
Rear cover fixing plate or are not hooked on the Up/down pinions on both right/left sides. And check also if each Connecting cords
are not extremely tense when the Massage mechanism block is at the highest position.
Caution
When installing the Rear cover, move the Massage mechanism block to the highest position first so as to prevent the hooking of
each Connecting cords. And wind the cord around the wire. If you wind the wire around the cord, the wire becomes bent.
To Next Page
Loading...
