Panasonic GTWIN - Page 71

GT Panel System Menu
GTWIN Reference Manual
70
Option name
Type of data copied
Restriction
[SD GT]
GT screen data
When you select the copy command, the password
entry screen is displayed. Enter the password set on
the GT to copy the screen data (see p. 113).
[GT  SD]
It is not possible to copy the GT screen data.
[SD  PLC]
PLC program files
It is not possible to copy the PLC program files.
[PLC SD]
PLC models available for program file transfer
The transfer of PLC program files is available for the following PLC models:
 FP-X
 FP
 FP0
 FP0R
 FP2
 FP2SH
 FP-e
 It is not possible to copy the comments in PLC programs created with
FPWIN GR.
 When you copy PLC program files from the PC where you have installed the
PLC programming software to the SD memory card, you need to create the
folder \plc_data in the root folder first. If the PLC program files are not
located in the correct folder, you cannot copy them to the PLC.
FPWIN GR
FPWIN Pro
Command for file
creation
File  Save
Online EPROM File
Services  Save in FP
Hex Format
Extras Backup Project
(select *.pce for the file type,
note 1)
File extension
*.FP
*.FP (note 2)
*.PCE (note 2)
Length of file name
8 alphanumeric characters
Content
PLC ladder programs,
system register
information
PLC ladder programs,
system register
information
FPWIN Pro project files
(except libraries)