21
VQT4C38
When the unit is turned on for the first time, a message asking you to set the date and time
will appear.
Select [YES] and perform
Step
s 2 to 3 below to set the date and time.
¬ Change the mode to .
1 Select the menu. (l 31)
2 Select the date or time using 2/1 and set the desired value using
3/4.
A Displaying the World time setting
(l 32):
[HOME]/ [DESTINATION]
≥ The year can be set between 2000 and
2039.
≥ The 24-hour system is used to display the
time.
3 Press the ENTER button.
≥ A message prompting for World Time setting may be displayed. Perform the World Time
setting by pressing the ENTER button. (l 32)
≥ Press the MENU button to complete the setting.
≥ The date and time function is driven by a built-in lithium battery.
≥ If the time display becomes [- -], the built-in lithium battery needs to be charged. To
recharge the built-in lithium battery, connect the AC adaptor or attach the battery to this
unit. Leave the unit as it is for approx. 24 hours and the battery will maintain the date and
time for approx. 4 months. (The battery is still being recharged even if the unit is off.)
Preparation
Setting date and time
: [SETUP] # [CLOCK SET]
WARNING
THE LITHIUM BATTERY IN THIS EQUIPMENT MUST ONLY BE REPLACED BY
QUALIFIED PERSONNEL. WHEN NECESSARY, CONTACT YOUR LOCAL PANASONIC
SUPPLIER.
HC-V10EB_VQT4C38_mst.book 21 ページ ２０１２年１月２４日 火曜日 午前９時３５分
To Next Page
Loading...
