50
VQT4C38
Manual shutter speed/iris adjustment
Shutter Speed:
Adjust it when recording fast-moving subjects.
Iris:
Adjust it when the screen is too bright or too dark.
≥ Press the iA/MANUAL button to switch to Manual Mode. (l 48)
1 Select [SHTR] or [IRIS] using the cursor button.
2 Press 2/1 to adjust settings.
A : Shutter speed:
1/50 to 1/8000
≥ If [AUTO SLOW SHTR] is set to [ON], the
shutter speed will be set between 1/25 and
1/8000.
≥ The shutter speed closer to 1/8000 is faster.
B : Iris/Gain value:
CLOSE
!#
(F16 to F2.0)
!#
OPEN
!#
(0dB to 18dB)
≥ Value closer to CLOSE darken the image.
≥ Value closer to 18dB brighten the image.
≥ When the iris value is adjusted to brighter than OPEN, it changes to the gain value.
≥ To return to auto setting, press the iA/MANUAL button.
≥ When setting both the shutter speed and the iris/gain value, set the shutter speed and then
set the iris/gain value.
Manual shutter speed adjustment
≥ You may see a band of light around an object that is shining very bright, or highly reflective.
≥ During normal playback, image movement may not look smooth.
≥ If you record an extremely bright object or record under indoor lighting, colour and screen
brightness may change or a horizontal line may appear on the screen. In this case, record
in the Intelligent Auto Mode or set the shutter speed to 1/100 in areas where the power
supply frequency is 50 Hz, or 1/125 in areas of 60 Hz.
Manual iris/gain adjustment
≥ If the gain value is increased, the noise on the screen increases.
≥ Depending on the zoom magnification, there are iris values that are not displayed.
ᧂ
OPENOPEN
1/100100
BACKBACKBACK
IRISIRISIRISIRISIRISIRIS
HC-V10EB_VQT4C38_mst.book 50 ページ ２０１２年１月２４日 火曜日 午前９時３５分
To Next Page
Loading...
