34
VQT4C38
When about 30 minutes have passed without any operation while connecting AC adaptor
with this unit, this unit automatically turns off.
≥ This unit will not automatically turn off even if the [ECONOMY (AC)] is set to [ON] in
following cases:
jUsing the USB cable for PC etc.
jPRE-REC is used
jDuring playback of the slide show
This unit is put into recording pause approx. 0.8 seconds after the LCD monitor is reopened.
≥ When in Quick Start Standby Mode about 60% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick Start will not work if there is no SD card inserted.
≥ The LCD monitor cannot be closed when using the USB cable, so please disconnect it
from the unit.
≥ Change the mode to .
1 Set [QUICK START] to [ON].
2 Close the LCD monitor.
The status indicator A flashes green and the unit
goes into Quick Start Standby Mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put
into recording pause.
≥ Quick Start Standby Mode is cancelled if
jabout 5 minutes have elapsed
jmode is set to
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY
(BATT)] (l 33)/[ECONOMY (AC)], close the LCD monitor once and open it again.
≥ Turn the unit off using the power button.
[ECONOMY (AC)]
[ON]/[OFF]
[QUICK START]
[ON]/[OFF]
HC-V10EB_VQT4C38_mst.book 34 ページ ２０１２年１月２４日 火曜日 午前９時３５分
To Next Page
Loading...
