- 109 -
Deleting part of a scene (AVCHD/Backup for Twin
Camera)
Unnecessary part of an AVCHD scene or a scene recorded as Backup for Twin Camera can be
deleted.
The deleted scenes cannot be restored.
≥ Press the recording/playback button to switch this unit to the Playback Mode, and touch
the play mode select icon. Then select an AVCHD scene or a scene recorded as Backup for
Twin Camera. (l 28)
1 Select the menu.
2 Touch the scene with a part to delete.
3 Set the section to delete by touching and sliding
the top and bottom section selection buttons
.
≥ It is convenient to use Slow-motion Playback and Frame-by-
frame Playback. (l 87)
4 Touch [ENTER].
5 Confirm (play back) the scene after editing by touching [YES].
≥ A confirmation message appears when [NO] is touched. Proceed to Step 7.
6 Stop the playback.
≥ A confirmation message appears.
7 Touch [ENTER].
≥ Repeat Steps 2-7 to continuously delete parts from other scenes.
To complete editing
Touch [Return].
≥ Deleting a part of a scene cannot be performed when there are 99 scenes in a single date.
≥ It may not be possible to delete part of a scene with a short recording time.
≥ The scene will be divided into two scenes when the middle part of a scene is deleted.
: [EDIT SCENE] # [SECTION DELETE]
≥
The relay information is deleted when part of a scene that was relay recorded is deleted, making it
impossible to perform the Relay scene combining. (l 114)
MENU
0h00m15s
0h00m15s
W580M
To Next Page
Loading...
