- 147 -
Preparations before using [Baby Monitor]
1 Check if the wireless access point is compatible with IEEE802.11b/g/n.
2 Install the smartphone application “Image App” on your smartphone. (l 167)
3 Set up a Wi-Fi connection between this unit and the wireless access point.
≥ [Easy Connection (WPS)] (l 170)
≥ Searching for wireless access points to set up a connection (l 171)
≥ Setting up a connection manually (l 172)
4 When the Wi-Fi connection is complete, follow the procedure in “Using [Baby
Monitor]”.
≥ Using [Wi-Fi Setup Wizard], you can also set up a Wi-Fi connection in conjunction with the
smartphone application “Image App”. (l 169)
Using [Baby Monitor]
≥ Proceed to Step 2 when your Wi-Fi connection has been made via [Set Wireless Access Point] in
[Wi-Fi Setup] (l 170 to 173).
1 Press Wi-Fi button on this unit.
2 Touch [Baby Monitor] on the Wi-Fi menu screen.
≥ The SSID of the wireless access point to which this unit is connected is displayed.
3 Connect the smartphone to a wireless access point.
≥ To connect it, select the SSID of the wireless access point displayed on the screen of this unit.
4 Start up the smartphone application “Image App”.
≥ When this unit is connected to the Internet via the wireless access point, the notification function,
which sends notifications from this unit to the smartphone, becomes available.
≥ When the connection to this unit is complete, the screen of this unit turns off. To turn on the
screen again, touch the screen.
To exit [Baby Monitor]:
Touch [EXIT] displayed on the screen of this unit or press the Wi-Fi button.
≥ The message is displayed. Touch [YES] to close the indication.
To Next Page
Loading...
