- 23 -
∫ Screen indications in the Motion Picture Recording Mode
≥ Screen display will disappear when no touch operation is performed for a specific period of time.
To display it again, touch the screen. (l 30)
≥ It will be constantly displayed when the remaining recordable time becomes less than 30 minutes.
≥ If the recording/playback button is pressed during motion picture recording, the recording
will stop and this unit will be switched to Playback Mode.
≥ To change the recording format, change the
[REC FORMAT] or [REC MODE]. (l 71, 72)
≥ Still pictures can be recorded while recording the motion picture. (l 25)
≥ The images recorded between pressing the recording start/stop button to start recording and
pressing it again to pause recording become one scene.
When you record scenes with [REC FORMAT] set to [MP4/iFrame], those exceeding 4 GB or
approximately 30 minutes will be divided automatically. (Recording will continue.)
≥ While recording is in progress, the recording will not stop even if the LCD monitor is closed.
≥ Please refer to page 218 for details about approximate recordable time.
Recording mode
R1h20m
Approximate remaining recordable time
≥ When the remaining time is less than
1 minute, R 0h00m flashes red.
0h00m00s
Recording time elapsed
≥ “h” is an abbreviation for hour, “m” for
minute and “s” for second.
≥ Each time the unit is put into recording
pause, the counter display will be reset
to 0h00m00s.
≥ (Maximum recordable scenes of a single SD card or built-in memory)
Recording format [AVCHD] [MP4/iFrame]
Recordable scenes Approx. 3900 Approx. 89100
Different dates (l 84) Approx. 900 Approx. 900
≥ Maximum number of recordable scenes and maximum number of different dates will be less than
above table when there are both MP4/iFrame scenes and still pictures recorded on an SD card or
the built-in memory.
0h00m00s
0h00m00s
R 1h20m
R 1h20m
To Next Page
Loading...
