Panasonic HC-X1 - Connecting to a Wireless Access Point; Searching for Wireless Access Points to Set up a Connection

- 147 -
≥ When [DIRECT] is selected, [SECURITY TYPE] is fixed to [WPA2-AES].
≥ Some settings in [BAND], [CHANNEL (2.4GHz)] and [CHANNEL (5GHz)] cannot be selected
depending on the wireless module used.
≥ For details on how to enter characters, refer to page 144.
3 Touch [RETURN].
4 Set [DHCP] to [SERVER].
5 Touch [EXIT].
6 Select the SSID of this unit from the Wi-Fi
®
setup of the iPad.
7 Enter the password into the iPad.
8 Check the network connection.
≥ When this unit is ready to be connected, will be displayed on its screen.
≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]
to [OFF].
Configure the settings in this section to connect this unit and an iPad using a wireless access point.
∫ Searching for wireless access points to set up a connection
≥ Attach a wireless module that support this unit to the USB HOST terminal of this unit.
(l 142)
≥ Set [USB MODE SELECT] to [HOST]. (l 197)
≥ Set [USB MODE] to [ON]. (l 197)
1 Select the menu.
2 Touch the wireless access point to connect to.
≥ The SSIDs of wireless access points found with the search will be displayed.
≥ If you touch [Refresh], you can search for wireless access points again.
3 Touch [ENTER].
≥ If an encryption key (password) is not set, the setup is complete.
4 (If an encryption key (password) is set)
Enter the password.
≥ For details on how to enter characters, refer to page 144.
≥ When the connection is complete, touch [Enter].
5 Check the network connection.
≥ When the connection is complete, is displayed on the screen of this unit.
≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]
to [OFF].
: [NETWORK SETUP] # [Wireless LAN setup] # [DHCP] # [SERVER]
Connecting to a wireless access point
: [NETWORK SETUP] # [WIRELESS SETUP] # [SSID(SELECT)]
MENU
MENU
HC-X1_GD_DVQP1183ZA_eng.book 147 ページ ２０１６年１１月２８日 月曜日 午前１１時４４分