- 22 -
∫ Attaching the front microphone
≥ The microphone holder is set up so that a 21 mm external microphone (AG-MC200G: optional)
can be attached. Check in advance whether the microphone you wish to use can be attached.
1 Attach the microphone holder to the microphone holder attachment part.
≥ Attach by using a commercially available screw driver.
≥ When attaching the microphone holder, be sure to tighten the screws firmly even though you
might hear a squeaking sound.
2 Attach an external microphone (optional) to the
microphone holder, and tighten the microphone
holder screw.
3 Connect the external microphone to the AUDIO
INPUT1 terminal (XLR 3 pin).
≥ When wiring the microphone cable, use the cable clamper of
this unit.
≥ Keep the microphone holder screw, INPUT terminal cap out of
reach of children to prevent swallowing.
∫ Attaching the INPUT terminal cap
Attach the INPUT terminal cap while the AUDIO INPUT1, 2 terminals (XLR 3 pin) are not used.
A Microphone holder attachment part
B Microphone holder
C Microphone holder mounting screws
D AUDIO INPUT1 terminal (XLR 3 pin)
E Microphone cable clamper
F Microphone holder screw
G External microphone (optional)
A INPUT terminal cap
HC-X1_GD_DVQP1183ZA_eng.book 22 ページ ２０１６年１１月２８日 月曜日 午前１１時４４分
To Next Page
Loading...
