- 58 -
∫ To change the peaking settings
If you set Focus Assist to ON by following either of the
procedures below, in-focus portions are highlighted with
color (peaking).
j Setting the menu item [FOCUS ASSIST 1] to
[PEAKING] or [BOTH] and pressing the FOCUS
ASSIST button or the USER button to which [FOCUS ASSIST 1] is registered.
j Setting the menu item [FOCUS ASSIST 2] to [PEAKING] and pressing the USER button to
which [FOCUS ASSIST 2] is registered.
G: Peaking
≥ You can set the peaking color and strength.
(When changing the peaking color)
Select the menu.
(When setting the peaking strength)
1 Select the menu.
2 Touch / to adjust settings.
≥ You can select a value between s7 and r7.
3 Touch [EXIT] to complete the setting.
(Notes on Focus Assist)
≥ Focus Assist is not possible in following cases:
j During Recording Check (l 88)
j During Freeze Frame (l 89)
j When color bars are displayed (l 106)
≥ Focus Assist is canceled in following cases:
j If you turn the unit off
j (If you operate the FOCUS ASSIST button or the USER button to which [FOCUS ASSIST 1] is
registered)
When the setting of [FOCUS ASSIST 1] (l 56) is changed
j (If you operate the USER button to which [FOCUS ASSIST 2] is registered)
When the setting of [FOCUS ASSIST 2] (l 56) is changed
j When you set this unit to Auto Focus
j When you press the USER button to which [FOCUS TRANS] is registered or touch the
applicable USER button icon (l 61)
≥ The magnified display and peaking are not displayed on recorded images.
≥ The magnified display and peaking are not displayed on an external monitor.
≥ Freeze Frame is not available when you use Focus Assist. (l 89)
: [SW SETUP] # [PEAKING COLOUR] # desired color
[Red]/[Blue]/[Yellow]/[White]
: [SW SETUP] # [PEAKING LEVEL] # desired setting
HC-X1_GD_DVQP1183ZA_eng.book 58 ページ ２０１６年１１月２８日 月曜日 午前１１時４４分
To Next Page
Loading...
