- 70 -
≥ It is not possible to adjust the gain value using the GAIN button and jog dial in the following
situations:
j During Freeze Frame (l 89)
≥ If the gain value is increased, the noise on the screen increases.
≥ In Auto Iris Mode or Auto Shutter Mode, the screen brightness may not change even if you adjust
the gain. (l 67, 71)
≥ When a negative gain value (a value between -3 dB and -1 dB) is selected, if you set
[EXTENDED SENSITIVITY] to [OFF], the gain value will be set to 0dB.
∫ Changing the maximum possible gain value for Auto Gain Mode
Select the menu.
You can use Super Gain by registering [SUPER GAIN] to a USER button.
Super Gain allows you to set the gain value to 30 dB or 36 dB.
≥ Please refer to page 82 for details about setting the USER button.
≥ Switch to Manual Mode. (l 44)
Press the USER button to which [SUPER GAIN] is registered or touch the
applicable USER button icon.
≥ To cancel Super gain, press the USER button or touch the USER button icon again.
∫ To change the gain value of Super Gain
Select the menu.
≥ Super Gain is not available in the following cases:
j In Auto Gain Mode
j During Freeze Frame (l 89)
j In High-sensitivity Recording Mode (l 166)
≥
Super Gain will be canceled if you set [HIGH SENS. MODE] to [HIGH SENS.].
: [AUTO SW] # [AGC LIMIT] # desired setting
[3 dB]/[6 dB]/[9 dB]/[12 dB]/[15 dB]/[18 dB]/[21 dB]/[24 dB]
Super Gain
: [SW SETUP] # [SUPER GAIN] # desired setting
[30 dB]/[36 dB]
HC-X1_GD_DVQP1183ZA_eng.book 70 ページ ２０１６年１１月２８日 月曜日 午前１１時４４分
To Next Page
Loading...
