Panasonic HC-X1 - Page 75

- 75 -
2 Use INPUT1 or INPUT2 switches to switch the connected audio input signal.
LINE
*1
: Audio equipment is connected
MIC
*2
: An external microphone is connected
+48V
*2
: When using a phantom microphone (which requires a power supply of +48 V)
*1 The input level varies depending on the [INPUT1 LINE LEVEL] or [INPUT2 LINE LEVEL]
setting. (l 187)
*2 The input level varies depending on the [INPUT1 MIC LEVEL] or [INPUT2 MIC LEVEL] setting.
(
l 187 )
3 Use the CH1 SELECT switch to select the input signal to be recorded to
audio channel 1.
INT(L): Audio from the built-in microphone L (left) ch is recorded to audio channel 1.
INPUT1:
Audio from a device connected to AUDIO INPUT1 terminal (XLR 3 pin) is recorded to channel 1.
INPUT2: Audio from a device connected to AUDIO INPUT2 terminal (XLR 3 pin) is recorded to channel 1.
4 Use the CH2 SELECT switch to select the input signal to be recorded to
audio channel 2.
INT(R): Audio from the built-in microphone R (right) ch is recorded to audio channel 2.
INPUT1:
Audio from a device connected to AUDIO INPUT1 terminal (XLR 3 pin) is recorded to channel 2.
INPUT2: Audio from a device connected to AUDIO INPUT2 terminal (XLR 3 pin) is recorded to channel 2.
∫ Table of audio input patterns
To remove the external microphone, etc., from the AUDIO INPUT1, 2 terminals
(XLR 3 pin)
Switch setting Channel or terminal used for signal input
CH1 SELECT
switch
CH2 SELECT
switch
Audio channel 1 Audio channel 2
INT(L)
INT(R) built-in microphone Lch built-in microphone Rch
INPUT1 built-in microphone Lch AUDIO INPUT1 terminal
INPUT2 built-in microphone Lch AUDIO INPUT2 terminal
INPUT1
INT(R) AUDIO INPUT1 terminal built-in microphone Rch
INPUT1 AUDIO INPUT1 terminal AUDIO INPUT1 terminal
INPUT2 AUDIO INPUT1 terminal AUDIO INPUT2 terminal
INPUT2
INT(R) AUDIO INPUT2 terminal built-in microphone Rch
INPUT1 AUDIO INPUT2 terminal AUDIO INPUT1 terminal
INPUT2 AUDIO INPUT2 terminal AUDIO INPUT2 terminal
Remove while pushing on the PUSH section of the AUDIO
INPUT1, 2 terminals (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
the CH1 SELECT, CH2 SELECT switches to INT (L) or
INT (R) after removing the external microphone. Audio
will not be recorded when motion picture is recorded
without switching.
A PUSH section
ヱヶヴラ
HC-X1_GD_DVQP1183ZA_eng.book 75 ページ ２０１６年１１月２８日 月曜日 午前１１時４４分