- 91 -
≥ Area mode is not possible in following cases:
j During Super Slow Recording (l 103)
j In Variable Frame Rate Mode (l 100)
j During AG ROP application connection (l 141)
≥ Area mode is canceled in following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j If you switch to a [REC FORMAT] setting with a frame rate of 24.00p. (l 161)
j When the setting of [ASPECT CONVERT] is changed (l 165)
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC (l 133)
≥ When using Area Mode, even if you set [ZEBRA] to [MARKER], the luminance display frame will
not be displayed. (l 97, 173)
In addition, the luminance level will not be displayed if [AREA MODE] is set to [FOCUS], [IRIS] or
[FOCUS/IRIS].
≥ Register [FOCUS TRANS] to a USER button. (l 82)
≥ Switch to Manual Focus Mode. (l 52)
With Focus Transition, you can move the current focus position to a pre-registered focus position.
(l 60)
≥ Register [PUSH AUTO] to a USER button. (l 82)
You can use the USER button as the PUSH AUTO button.
≥ Pressing the USER button or touching the USER button icon in Manual Focus Mode allows you
to use One Push AF. (l 55)
≥ Pressing and holding the USER button or touching and holding the USER button icon in Manual
Focus Mode allows you to use Push AF. (l 56)
≥ Register [EVF/LCD DETAIL] to a USER button. (l 82)
[EVF/LCD DETAIL] helps you achieve focus easier by emphasizing the outlines of an image
displayed on the LCD monitor or the viewfinder. (l 53)
≥ T
hese settings will not affect the images actually recorded.
[FOCUS TRANS]
[PUSH AUTO]
[EVF/LCD DETAIL]
HC-X1_GD_DVQP1183ZA_eng.book 91 ページ ２０１６年１１月２８日 月曜日 午前１１時４４分
To Next Page
Loading...
