119
VQT2W75
“ERROR OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN ON
AGAIN.” is displayed.
≥ The unit has automatically detected an error. Restart
the unit by turning off and on.
≥ The unit will be turned off in about 1 minute if the
unit is not turned off and on.
≥ Repair is needed if it is repeatedly displayed even if
it is restarted. Detach the power connected, and
consult the dealer who you purchased this unit from.
Do not attempt to repair the unit by yourself.
VIERA Link does not
work.
[Setting on this unit]
≥ Connect with a HDMI mini cable (optional). (l 86)
≥ Press the MENU button, then touch [SETUP] #
[VIERA Link] # [ON]. (l 86)
≥ Turn the unit off and then back on again.
[Setting on other devices]
≥ If the TV input does not switch automatically, switch
the input using the TV remote control.
≥ Check the VIERA Link setting on the connected
device.
≥ Please refer to the operating instructions of the
connected device.
When connected by the
USB cable, this unit is
not detected by the PC.
≥ After re-inserting the SD card into the unit,
reconnect the supplied USB cable.
≥ Select another USB terminal on the PC.
≥ Check the operating environment. (l 98, 107, 108)
≥ Connect the supplied USB cable again after
restarting the PC and turning on this unit again.
When the USB cable is
disconnected, an error
message will appear on
the PC.
≥ To disconnect the USB cable safely, double-click the
icon in the task tray and follow the instructions
on the screen.
Problem Check points
HDC-SDX1GC-VQT2W75_mst.book 119 ページ ２０１０年６月２１日 月曜日 午後３時１２分
To Next Page
Loading...
