Camera is searching for an access point
*1
Green or yellow
(amber) blinking
quickly - off for 1
second
or
Camera is on
*1
Red
Registration failed, signal level is weak
*3
, or detecting motion
*1,
*4
Camera is out of range of the access point
*1,
*3
Streaming data
*1
Yellow (amber)
Not registered to the access point
*2
, or signal level is good
*3
Battery is running low
*1
*1 You can configure the camera so that its LED indicator does not light in most states. See “Status
LED”, Page 140.
*2 The LED indicator lights in yellow (amber) for 5 seconds after the power is turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 136.
*4 Motion detection can also be checked from “Detection test”, Page 140.
Front door camera and outdoor camera charging LED indicator
Red Charging is completed
Charging
Charging failure
HD camera LED indicator
Off
No power, or LED indicator is turned off
*1
Blue
Normal operation, connected to wireless router
*1
, privacy shutter is open
White
Normal operation, connected to wireless router
*1
, privacy shutter is closed
Camera is searching for wireless router
Green Initial setup required
Initial setup is in progress with mobile device connected
Initial setup is starting
Red
Motion detected
*1
, or camera is starting up
Live images are being viewed or recorded, or camera is starting up
Device malfunction
30
Getting started with the HomeHawk!
To Next Page
Loading...
