Component Identification
11
∫ Power turn-on sequence
1
Turn on the power of the scanner.
≥ The LED will now light.
2
Turn on the power of the host
computer after scanner’s LED stays
green
.
≥ In case of the USB connection, the host
computer recognizes the scanner auto-
matically when the scanner is powered on
even after the host computer is powered
on.
∫ About LED
LED indicates the status of the scanner as follows:
*1: The rollers need to be cleaned or replaced.
Refer to Maintenance Manual or Operating Instructions (CD-ROM) for the way of cleaning or replacing the
rollers.
*1, *2: Check the status of the scanner using the User Utility.
The User Utility is included in the CD-ROM.
LED light Status
Green Ready to scan or scanning
Green (flashing) Sleep mode
Orange Ready to scan or scanning with warning *1
Orange (flashing) Initializing
Sleeping with warning *1
Red An error occurred *2
LED
Power switch
To Next Page
Loading...
