7. Answering Machine
49
L The display will show the remaining
recording time.
6 When finished recording, press {STOP}.
L The unit will repeat your message.
7 Press {MENU}.
To check the transfer greeting message
1. Press {MENU}, {#}{6}{1}.
2. Press {A} or {B} repeatedly to select
“CHECK”.
3. Press {SET}.
L The unit will play the message.
4. Press {MENU}.
To erase your transfer greeting message
1. Press {MENU}, {#}{6}{1}.
2. Press {A} or {B} repeatedly to select
“ERASE”.
3. Press {SET}.
4. Press {MENU}.
Note:
L When transferring a call, the pre-recorded
transfer greeting message will be played.
Pager call
This feature allows your unit to call your pager
when your unit receives an incoming voice
message.
1. Press {MENU}.
2. Press {#}, then {7}{0}.
3. Press {A} or {B} repeatedly to select “ON”.
4. Press {SET}.
5. Enter your pager number up to 30 digits.
6. Press {SET}.
7. Enter your pager access code up to 10 digits
if required.
8. Press {SET}.
MSG.=07734
L The default code 07734 will show “Hello!”
on your pager.
L If you want to change this message, enter
your message up to 30 digits.
9. Press {SET}.
L The unit will dial the stored number.
10.Check that your pager received the pager
test call.
11.Press {DIGITAL SP-PHONE}.
Note:
L If you have subscribed to a Caller ID service,
instead of the message you entered in step 8,
your pager will display the caller’s telephone
number.
FP145.book Page 49 Thursday, January 15, 2004 10:46 AM
To Next Page
Loading...
