KX-FT21LA
- 14 -
1
Open the cover by pressing the cover open button
and install the recording paper roll.
If the paper is secured with glue or tape, cut
approximately 15 cm (6 inches) from the
beginning.
3. INSTALLING THE RECORDING PAPER
INSTALLATION
Note:
Only use the included roll of paper or specified recording paper, or else the print quality may be
affected and/or excessive thermal head wear may occur.
For accessory order information.
When the power cord is connected, everytime you close the cover a message will be printed. If the recording
paper is set to the wrong side, the message will not be printed. Install the paper correctly.
correct
incorrect
4
Tear off the excess paper by pulling it
towards you.
3
Close the cover securely by pushing down on
both ends.
2
Pull the leading edge of the paper approximately
10 cm (4 inches) out of the unit.
Make sure that there is no slack in the
paper roll.
Cover open
button
10 cm
Document stacker
Install the document stacker.
Document stacker
To Next Page
Loading...
