KX-FT21LA
- 56 -
END
After the call is connected,
ask the user to press the MENU button.
Enter the remote programming ID: "9, 0, 0, 0, ".
A high-pitched beep ("Piii") sounds to indicate that
the remote programming mode has been activated.
Enter the 3 digit code ( Program mode table:
refer to page 57) of the desired service function
and then press (set).
A high-pitched beep ("Piii") sounds to indicate that
the service setting mode has been activated.
Enter the 1 to 3 digit code ( Program mode
table: refer to page 57) of the desired function
and then press (set).
Two short high-pitched beeps ("Pi Pi") sound to
indicate that the setting is complete.
To make another setting
To quit the remote programming mode, ask
the customer (the call should still be
connected) to press the STOP key to return
the machine to the normal mode.
Then hang up the phone.
If nothing is audible, enter "9, 0, 0, 0, "
again.
Three short high-pitched beeps ("Pi Pi Pi") sound if
an invalid code was entered. If this happens,
reenter the correct code.
Three short high-pitched beeps ("Pi Pi Pi") sound if
an invalid value was entered. If this happens,
reenter the correct value.
Obtain a list (991: Set up list, 999: Service list) to confirm that the changes
were made correctly.
2
2
If the user is talking with speaker phone,
ask the user to lift the handset.
‡@ Entering the remote programming mode and changing service codes.
To Next Page
Loading...
