2.4 Selecting the operation mode
(Scan/Copy/Fax)
You can select the desired mode by pressing one of the
following buttons.
– MSCANN: Select this mode when using the unit as a
scanner (page 30).
– MCOPYN: Select this mode when using the unit as a
copier (page 33).
– MFAXN: Select this mode when using the unit as a fax
machine (page 39).
Note:
R The default operation mode is the copy mode.
R You can change the default operation mode (feature
#463 on page 59) and the timer before returning to
the default operation mode (feature #464 on
page 59).
2.5 Setting the original
2.5.1 Using the scanner glass
1 Open the document cover (A).
2 Place the document FACE DOWN on the scanner
glass (B), aligning the top left of the document with
the corner where the mark is positioned.
3 Close the document cover.
Note:
R Confirm that there are no documents in the automatic
document feeder.
R Place the original onto the scanner glass gently. To
avoid malfunction, do not press down too firmly.
R If the original is a thick book, do not close the
document cover.
R Confirm that any ink, paste or correction fluid has
dried completely.
R Effective scanning area is shown by the shaded area:
Effective scanning area
208 mm
289
mm
4 mm
4 mm
4 mm
4 mm
19
2. Preparation
To Next Page
Loading...
