Feature/Code Selection
Setting the waiting time for
the power save mode
MBNM4NM0NM3N
To set the length of time before the unit enters power save mode.
M1N “1min” (default)
M2N “5min”
M3N “15min”
M4N “30min”
M5N “45min”
Note:
R During power save mode, the unit needs to preheat the fuser unit before it
can begin printing.
Holding the previous contrast
setting
MBNM4NM6NM2N
M0N “DISABLED” (default): Deactivates this feature.
M1N “ENABLED”: The unit will hold the previous setting.
Note:
R The previous setting will be held individually for copying.
R The previous setting will be held individually for sending faxes.
Setting the default operation
mode
MBNM4NM6NM3N
To select the default operation mode when the selected time of the mode timer
(feature #464) passes.
M1N “COPY” (default): Copy mode is selected as default.
M2N “FAX”: Fax mode is selected as default.
Note:
R You cannot select the scan mode using this feature.
Setting the default operation
mode timer
MBNM4NM6NM4N
To set the timer before returning to the default operation mode (feature #463).
M0N “OFF”: Deactivates this feature.
M1N “30s”: 30 seconds
M2N “1min” (default): 1 minute
M3N “2min”: 2 minutes
M4N “5min”: 5 minutes
Viewing the counter for
departments
MBNM4NM7NM9N
See page 79 for details.
Setting toner save feature
MBNM4NM8NM2N
M0N “OFF” (default): Deactivates this feature.
M1N “ON”: The toner cartridge will last longer.
Note:
R This feature may lower the print quality by reducing toner consumption.
R This setting is valid for copying, and when the unit prints reports/lists.
R This setting is invalid for printing received faxes.
59
9. Programmable Features
To Next Page
Loading...
