Panasonic KX-MB2090CX

4. Press MCN or MDN repeatedly to display the desired
item. A MMENUN A MGN
5. Edit the name if necessary. A MSETN
6. Edit the department code if necessary. A MSETN
7. Edit the department settings if necessary. Press MCN
or MDN repeatedly to select the desired setting. A
MSETN
8. MSTOPN A MMENUN
Erasing a stored item
Important:
R Make sure feature #154 is set to “ON” beforehand
(page 78).
1. Press MMENUN repeatedly to display “DEPARTMENT
SETUP”. A MEN
2. Enter the administrator code (feature #151 on
page 56). A MSETN
3. Press MFN or MEN repeatedly to select “EDIT”. A
MSETN
R To erase all items, press MFN or MEN repeatedly
to select “ERASE ALL”. A MSETN A MSETN
A MSTOPN
4. Press MCN or MDN repeatedly to display the desired
item. A MMENUN A MBN
R To cancel erasing, press MSTOPN.
5. MSETN A MMENUN
10.4.2 Counter view and print for
departments
Viewing the count number of copies/prints for
departments
1. MMENUN A MBNM4NM7NM9N A MSETN
2. Enter the administrator code (feature #151 on
page 56). A MSETN
3. Press MCN, MDN, MFN or MEN repeatedly to select the
desired item. A MMENUN
Printing the reports of the count number of copies/
prints for departments
1. Press MMENUN repeatedly to display “PRINT
REPORT”.
2. Press MFN or MEN repeatedly to select “DEPT.PRINT
COUNT”. A MSETN
3. Enter the administrator code (feature #151 on
page 56). A MSETN
4. MMENUN
Resetting the counter for departments
1. Press MMENUN repeatedly to display “DEPARTMENT
SETUP”. A MEN
2. Enter the administrator code (feature #151 on
page 56). A MSETN
3. Press MFN or MEN repeatedly to select “RESET
COUNTER”. A MSETN
4.
MSETN A MSTOPN
R To cancel resetting, press MSTOPN.
Note:
R The count numbers of copies/prints will be reset only
when the mode restriction (feature #154 on page 78)
is activated.
79
10. Useful Information