Feature/Code Selection
Setting recall/flash time
MBNM1NM2NM1N
The recall/flash time depends on your telephone exchange or host PBX.
M0N “900ms”
M1N “700ms” (default)
M2N “600ms”
M3N “400ms”
M4N “300ms”
M5N “250ms”
M6N “200ms”
M7N “160ms”
M8N “110ms”
M9N “100ms”
MGN “90ms”
MBN “80ms”
Note:
R If the unit is connected via a PBX, PBX functions (transferring a call, etc.)
might not work correctly. Consult your PBX supplier for the correct setting.
Setting the ADSL mode
MBNM1NM2NM4N
When you use a DSL/ADSL line, this feature improves the reliability by reducing
the transmission speed.
M0N “OFF” (default)
M1N “ON”
Note:
R Calling charges may be higher than usual.
Changing the LCD display
contrast
MBNM1NM4NM5N
M1N “-2”
M2N “-1”
M3N “0” (default)
M4N “1”
M5N “2”
Selecting the scale
MBNM1NM4NM7N
M1N “MILLIMETRES” (default)
M2N “INCHES”
Note:
R The selected scale will be used when measurements are shown on the
unit’s display.
Setting the display interval
MBNM1NM4NM8N
To set display interval for messages showed alternately.
M1N “1sec” (default)
M2N “2sec”
M3N “3sec”
M4N “4sec”
M5N “5sec”
Changing the administrator
code for mode restriction
settings
MBNM1NM5NM1N
1. MMENUN A MBNM1NM5NM1N A MSETN
2. Enter the current administrator code. A MSETN
R The default administrator code is “0000”.
3. Enter a new 4–digit administrator code using 0–9. A MSETN
4. Enter the new administrator code again. A MSETN A MMENUN
Note:
R It is recommended that you change this administrator code from the default
administrator code.
Setting the mode restriction
MBNM1NM5NM4N
See page 78 for details.
56
9. Programmable Features
To Next Page
Loading...
