9.1.5 Scan features
Feature/Code Selection
Setting the scan mode for
Push Scan
MBNM4NM9NM3N
M1N “VIEWER” (default): The scanned image will be displayed in the
[Multi-Function Viewer] window.
M2N “FILE”: The scanned image will be saved as a file.
M3N “EMAIL”: The scanned image will be saved for email attachment.
M4N “OCR”: The scanned image will be displayed in the OCR window.
M5N “EMAIL ADDRESS”: The scanned image will be sent as an attachment
without using email software.
M6N “FTP SERVER”: The scanned image will be sent to the pre-programmed
folder on the FTP server.
M7N “SMB FOLDER”: The scanned image will be sent to the pre-programmed
SMB folder.
Note:
R Following selections will be displayed only when the server setting is
programmed through the web browser interface in advance (KX-MB2090
only).
– “EMAIL ADDRESS” will be displayed when the email server setting is
programmed (page 74).
– “FTP SERVER” will be displayed when the FTP server setting is
programmed (page 73).
– “SMB FOLDER” will be displayed when the SMB folder setting is
programmed (page 73).
Holding the previous
scanning parameter for Push
Scan
MBNM4NM9NM4N
M0N “DISABLED” (default): Deactivates this feature.
M1N “ENABLED”: The unit will hold the previous scan settings for each mode of
push scan.
68
9. Programmable Features
To Next Page
Loading...
