Feature/Code Selection
Setting the IP address
automatically for the LAN
connection
MBNM5NM3NM3N
This feature will be displayed only when feature #500 is activated.
M0N “DISABLED” (default): Deactivates this feature.
M1N “ENABLED”: IP address will be allocated automatically without using a
DHCP (Dynamic Host Configuration Protocol) server.
Setting HTTPD for the LAN
connection
MBNM5NM3NM4N
M0N “DISABLED”: Denies access to the web server.
M1N “ENABLED” (default): Allows access to the web server.
IPv6 protocol
MBNM5NM3NM5N
M0N “DISABLED” (default): Deactivates this feature.
M1N “ENABLED”: IPv6 protocol can be used. After installing the printer driver,
be sure to change the port to IPv6 protocol. You can check the IPv6 protocol
address by printing the “SETUP LIST” (page 109).
Note:
R To activate this feature, you need to turn the power switch of the unit OFF,
then ON.
Setting the primary WINS
server for the LAN
connection
MBNM5NM3NM8N
This feature is available when feature #500 is deactivated.
1. MMENUN A MBNM5NM3NM8N A MSETN
2. Enter the primary WINS server of the network on the LAN using the dial
keypad. A MSETN A MMENUN
Setting the secondary WINS
server for the LAN
connection
MBNM5NM3NM9N
This feature is available when feature #500 is deactivated.
1. MMENUN A MBNM5NM3NM9N A MSETN
2. Enter the secondary WINS server of the network on the LAN using the dial
keypad. A MSETN A MMENUN
Erasing all email addresses,
FTP destinations, and SMB
folder destinations stored in
the unit
MBNM5NM7NM8N
M0N “NO” (default)
M1N “YES”
R Disconnect the telephone line cord, USB cable and LAN cable before
activating this feature.
To erase all email addresses:
1. MMENUN A MBNM5NM7NM8N
2. Press M1N to select “YES”. A MSETN
3. Press M1N to select “YES”. A MSETN A MMENUN
To erase FTP destinations:
1. MMENUN A MBNM5NM7NM8N
2. Press M1N to select “YES”. A MSETN
3. Press M0N to select “NO”. A MSETN
4. Press M1N to select “YES”. A MSETN A MMENUN
To erase SMB folder destinations:
1. MMENUN A MBNM5NM7NM8N
2. Press M1N to select “YES”. A MSETN
3. Press M0N to select “NO”. A MSETN
4. Press M0N to select “NO”. A MSETN
5. Press M1N to select “YES”. A MSETN A MMENUN
70
9. Programmable Features
To Next Page
Loading...
