Panasonic KX-NCP1000 - Page 30

3.
a. Click DN2IP.
b. When using the PBX code method:
In the Leading Number box, type the remote PBX
code and starting digit of destination extension.
When using the extension number method:
In the Leading Number box, type the remote PBX
code and starting digit of destination extension.
c. In the Remaining Number of Digits box, type a
number of
digits to dial following the leading number.
d. In GW No./GW Group Selection, select GW No..
e. In the GW No. box, select 1 (the gateway entry for
the destination gateway device at the remote PBX).
f. Click OK.
Note
For more details about gateway settings, refer to "3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway
—
GW Settings" in the PC Programming Manual.
30 Getting Started
4.2.2 Programming the Address Translation Table