Panasonic KX-NCP1000 - Page 33

7.
a. Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
b. Click INS.
*1
When "En-bloc" is selected, you need to press
"#" after dialling the phone number.
Programming for the Extension Number Method
1.
a. Under Configuration, click Slot.
b. Move the mouse pointer over the PBX image of
IPCMPR Virtual Slot at the top of the screen.
c. Click Select Shelf.
d. Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
e. Click Port Property.
Confirm that all ports are in service (INS).
Note
When a V-IPGW16 card is installed, 8 ports (1–8)
are available. When two V-IPGW16 cards are
installed, 16 ports (1–
16) are available.
2.
a. From the system menu, click CO & Incoming Call.
b. Click CO Line Settings.
c. Type the CO Name and assign an unused Trunk
Group Number to be used for all IP trunks.
d. Click OK.
3.
a. From the system menu, click System.
b. Click Numbering Plan.
c. Click Main.
d. Click the Other PBX Extension tab.
e. In the Other
PBX Extension Numbering (TIE) box,
type a starting digit of destination extension.
f. Click OK.
Getting Started 33
4.2.3 Programming the Network Settings