Note
To confirm the connection to the secondary PBX after programming, (1) turn the IP-PT’s power off,
and (2) hold the STORE button and 2
key while turning the power on.
KX-NT265 (Software version 2.00 or later only)
Subnet Mask Address*
2
Default Gateway Address*
3
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address (if required)
To start programming
Supply power to the IP-PT.
Press PROGRAM
while "Searching" is displayed.
PROG.
Press VOLUME to
select "Subnet Mask".
VOL
Press SP-PHONE. Press SP-PHONE.
Press VOLUME to
select "Default GW".
VOL
Press SP-PHONE. Press SP-PHONE.
To end programming
The IP-PT will reboot
and can then be
registered to the PBX.
Press STORE.
IP Address*
1
Press VOLUME to
select "Network".
VOL
Press SP-PHONE. Press VOLUME to
select "DHCP (Disable)".
VOL
Press SP-PHONE
twice.
Press SP-PHONE.
Press HOLD to return
to the Menu screen.
HOLD
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range:
"0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Getting Started 43
4.3.1 Assigning the IP Addressing Information
To Next Page
Loading...
