KX-TA Advanced Hybrid System
E&OE Issue 2
20
Preferred Line Assignment — Outgoing
A proprietary telephone user can select a desired outgoing line preference to make outside
calls from the following 3 line preferences. System Programming and Proprietary Telephone
Settings are required.
Idle Line Preference
When the user goes off-hook, they are connected to an idle line. An idle line is automatically
selected.
Prime Line Preference
When the user goes off-hook, they are connected to thier pre-assigned line. Assign one prime
line beforehand.
No Line Preference
No line is selected when the user goes off-hook. They must select a line to make a call.
Recall
The RECALL button is used to allow a proprietary telephone user to access BT “Star
Services” or features of a host PBX. It may also be used to disconnect the current call and
originate another call without hanging up.
Recall Button on a Single Line Telephone
Pressing the Recall button is used to allow a single line telephone user to hold a call for
transferring or holding.
Redial
Last Number Redial
Every extension automatically saves the last telephone number dialled so that the extension
user can make a call to the same party later using a simple operation.
Saved Number Redial
Allows a proprietary telephone user to save the current external telephone number in the
SAVE button during a conversation, so that the extension user can redial the same party later
using a simple operation. The saved number can be redialled until another number is stored. A
flexible button can be assigned as the SAVE button in the Proprietary Telephone Settings.
Ringing Pattern Selection
A ringing pattern can be selected depending on the type of call such as an outside call,
intercom call and doorphone call. There are 4 ringing patterns available
To Next Page
Loading...
