Why does my Panasonic Telephone System beep during a conversation?
If you hear two short beeps during a conversation on your Panasonic Telephone System, it means the radio signal is weak. Try moving closer to the base unit.
What does "CS Busy" mean on Panasonic Telephone?
If your Panasonic Telephone displays "CS Busy", it means the radio channel is busy. Please try again later.
Why can't I dial on my Panasonic Telephone?
If you cannot dial on your Panasonic Telephone, it might be because the number you dialed is restricted by the system, so you should consult your dealer. Alternatively, the key lock mode might be set. To cancel the mode, press the Function button for about 2 seconds. Also, the radio channel might be busy or a radio communication error occurred, so try again later.
What to do if there is noise in external paging on Panasonic Telephone System?
If you're experiencing noise in external paging with your Panasonic Telephone System, the issue might be induced noise on the wire between the system and the amplifier. Use a shielded cable as the connection wire between the system and amplifier. A short shielded cable is recommended.
What does 'Please Wait...' mean on my Panasonic Telephone System?
If your Panasonic Telephone System displays 'Please Wait...', it means the handset is connecting to the base unit. Wait for a moment.
Why do beep tones sound and '(needs to be charged)' flashes on my Panasonic Telephone System after charging?
If you charged the battery for 7 hours, but the beep tones sound every 5 seconds and '(needs to be charged)' flashes after a few telephone calls, the battery charge contacts may be dirty. Clean the battery charge contacts without damaging them and charge once more. It may also mean it is time to change the battery and replace it with a new one.
Why does my Panasonic Telephone System say 'No Service'?
If your Panasonic Telephone System displays 'No Service', it could be due to a couple of reasons. First, the handset might be out of range, so try moving closer to the base unit. Alternatively, the base unit might be turned off, so ensure the power cord is properly connected.
What to do if I cannot make or receive calls on my Panasonic Telephone System?
If you're unable to make or receive calls on your Panasonic Telephone System, it could be due to the handset being out of range. Try moving closer to the base unit. Also, ensure the telephone line is properly connected.
What to do if originating an intercom/ outside call from one system to the other system is not possible during system connection operation for KX-TD1232 Panasonic Telephone System?
If you cannot originate an intercom/outside call from one system to the other during system connection operation for KX-TD1232 Panasonic Telephone System, the interface between the systems may be disconnected. Connect the interface between the systems and press the Reset Button on both systems.
Why does the battery icon flash during a conversation on my Panasonic Telephone?
If the battery icon flashes or beeping tones sound every 5 seconds during a conversation on your Panasonic Telephone, it indicates that the battery is low. Charge the batteries fully.
General| Maximum CO lines | 8 |
|---|---|
| Extensions | 8 |
| Expandable Extensions | 16 |
| Maximum Extensions | 24 |
| Expandable | Yes |
| Caller ID | Yes |
| Call Forwarding | Yes |
| Call Waiting | Yes |
| DISA/OGM | Yes |
| Doorphone Interface | Yes |
| SMDR | Yes |
| Power Failure Transfer | Yes |
| Intercom | Yes |
| Music on Hold | Yes |
| Conference | Yes |
| Door Phone | Yes |
| Type | Digital |
| Lines | 3 |
| Weight | 6.6 lbs |
To Next Page
