To Next PageTo Next PageWhy doesn't my headset work with my Panasonic Telephone System?
If your headset doesn't work with your Panasonic Telephone System, ensure the headset tone setting is set to on. Also, make sure the headset jack is connected properly.
Why can't I use the handset during a power failure with my Panasonic Telephone System?
The handset will not function during a power failure because the base unit stops emitting radiowaves.
Why does my Panasonic Telephone System say 'Memory Empty'?
If your Panasonic Telephone System displays 'Memory Empty' when trying to view the Phonebook, it means no items have been stored. If this occurs when trying to view the Incoming or Outgoing Call Log, it means no logs have been stored.
Why does my Panasonic Telephone System say 'Memory Full'?
If your Panasonic Telephone System displays 'Memory Full', it means the Phonebook is full and cannot store the new item. Remove unnecessary data in the Phonebook, and try again.
Why does my Panasonic Telephone System not store all received calls in the Incoming Call Log?
If some received calls are not stored in the Incoming Call Log of your Panasonic Telephone System, it is because incoming calls via Voice Call/Paging/LCS/Auto Answer cannot be stored. Set at least one of the incoming call types to On.
Why are some dialed calls not stored in the Outgoing Call Log of my Panasonic Telephone System?
Outgoing calls using some PBX features (e.g., Redial, One-touch Dialing or Speed Dialing) cannot be stored in the Outgoing Call Log.
Why do beep tones sound and '(needs to be charged)' flashes on my Panasonic Telephone System after charging?
If you charged the battery for 7 hours, but the beep tones sound every 5 seconds and '(needs to be charged)' flashes after a few telephone calls, the battery charge contacts may be dirty. Clean the battery charge contacts without damaging them and charge once more. It may also mean it is time to change the battery and replace it with a new one.
What to do if my Panasonic Telephone System handset does not work?
If your Panasonic Telephone System handset isn't working, there could be several reasons. First, the battery might be drained, so charge it fully. If that doesn't work, check if the power is turned off and turn it on. As a last resort, try re-inserting the battery.
Why does my Panasonic Telephone not ring?
If your Panasonic Telephone does not ring, it might be because the ringer volume is set to OFF or VIBRATION. To resolve this, set it to ring by pressing the Volume Control button. Alternatively, the PS might be out of range, or the Cell Station (CS) could be busy, so move closer to the CS or try again later. Also, the radio channel might be busy, or a radio communication error might have occurred, so try again later.
Why can't I dial on my Panasonic Telephone?
If you cannot dial on your Panasonic Telephone, it might be because the number you dialed is restricted by the system, so you should consult your dealer. Alternatively, the key lock mode might be set. To cancel the mode, press the Function button for about 2 seconds. Also, the radio channel might be busy or a radio communication error occurred, so try again later.
General| Maximum CO lines | 8 |
|---|---|
| Extensions | 8 |
| Expandable Extensions | 16 |
| Maximum Extensions | 24 |
| Expandable | Yes |
| Caller ID | Yes |
| Call Forwarding | Yes |
| Call Waiting | Yes |
| DISA/OGM | Yes |
| Doorphone Interface | Yes |
| SMDR | Yes |
| Power Failure Transfer | Yes |
| Intercom | Yes |
| Music on Hold | Yes |
| Conference | Yes |
| Door Phone | Yes |
| Type | Digital |
| Lines | 3 |
| Weight | 6.6 lbs |
