Panasonic KX-TCD210FX

Base Unit Settings
31
If you select “No Ringing”, the base unit
will not ring during night mode.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
32).
4 Select “Ringer Setup”, then press
{>}.
5 Select “Night Mode”, then press {>}.
6 Select “Ring Delay”, then press {>}.
7 Select the desired setting, then press
{>}.
8 Press {ih}.
Call options
Setting dialling mode
(tone/pulse)
“Tone”: Select when you have a touch tone
service.
“Pulse”: Select when you have rotary or
pulse service.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
32).
4 Select “Call Options”, then press
{>}.
5 Select “Dial Mode”, then press {>}.
6 Select the desired setting, then press
{>}.
7 Press {ih}.
Changing the recall time
Change the recall time, if necessary,
depending on the requirements of your
service provider or PBX.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
32).
4 Select “Call Options”, then press
{>}.
5 Select “Recall”, then press {>}.
6 Select the desired setting, then press
{>}.
7 Press {ih}.
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your
service provider or PBX.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
32).
4 Select “Call Options”, then press
{>}.
5 Select “Pause Length”, then press
{>}.
6 Select the desired setting, then press
{>}.
7 Press {ih}.
Storing/changing emergency
numbers
These settings determine which phone
numbers can be dialled while the call bar
feature is on (page 27).
TCD210220FX(e-e).book Page 31 Tuesday, January 18, 2005 9:04 AM