SMS (Short Message Service)
39
4 Press {ih}.
Storing the sender’s number in
the handset phonebook
1
While reading a received message,
press {j/OK}.
2 Select “Add Phonebook”, then press
{>}.
3 Continue from step 3, “Adding entries to
the handset phonebook”, page 17.
Editing the sender’s number
before calling back
1
While reading a received message,
press {j/OK}.
2 Select “Edit and Call”, then press
{>}.
3 Edit the number, then press {C} or
{s}.
Guide to SMS settings
If the base unit is reset to its default settings
(page 33), the following SMS-related
settings will be reset.
Note:
L If the base unit is reset to its default
settings, the contents of the receive and
send lists will be erased.
Storing the PBX line access
number (for PBX users only)
Store your PBX line access number (4 digits
max.) so that SMS messages are sent
properly. When sending SMS messages to
entries in the handset phonebook or redial
list, the PBX line access number will be
deleted.
1 Press {j/OK}.
2 Select “SMS”, then press {>}.
3 Select “Settings”, then press {>}.
4 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
32).
5 Select “PBX Access No.”, then press
{>}.
6 Select “On”, then press {>}.
7 Enter your PBX line access code and a
dialling pause, if necessary, then press
{j/OK}.
8 Select “Save”, then press {>}.
SMS settings Default
setting
Page
SMS on/off Off page 36
Message
Centre 1
—page 36
Message
Centre 2
—page 36
PBX line
access number
Off page 39
TCD210220FX(e-e).book Page 39 Tuesday, January 18, 2005 9:04 AM
To Next Page
Loading...
