Preparation
9
Displays
Display icons
Various icons appear on the handset display
to indicate the current status of the unit.
Connections
When the AC adaptor is connected, a short
beep will be heard. If it is not heard, check
the connections.
Important:
L Use only the AC adaptor and telephone
line cord supplied with this unit.
Note:
L After connection, you must charge the
batteries to make or answer calls (page
10).
L Never install telephone wiring during a
lightning storm.
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor to
feel warm during use.)
L The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become
disconnected.
Display
icon
Meaning
w Within range of a base unit
L When flashing: Handset
is searching for base unit.
(out of range of base unit,
handset is not registered
to base unit, no power on
base unit)
L Handset is accessing base
unit. (intercom, paging,
changing base unit settings,
etc.)
k Handset is on an outside
call.
o Call bar is on. (page 27)
u Answering system is on.
(KX-TCD220 only; page 43)
5 Battery strength
[VE] Voice enhancer is set to
high or low tone. (page 14)
[N] Night mode is on. (page 25)
[X] Key lock is on. (page 14)
[2] Handset number: The left
icon shows handset 2
example. (page 26)
-2- Base unit number: The left
icon shows base unit 2
example. (page 26)
F New SMS message
received (SMS users only;
page 38)
Line is being used by
another handset.
(220–240 V, 50 Hz)
To telephone
network
Hooks
TCD210220FX(e-e).book Page 9 Tuesday, January 18, 2005 9:04 AM
To Next Page
Loading...
