Panasonic KX-TD1232 - Introduction; Who Should Use This Manual; Construction of This Manual

6
Display example: DECT-SYS LOCK
PASSWORD =----
6.
Enter a System Lock password and press the AUTO/OK button, if required.
Display: DECT-SYS LOCK
PASSWORD =****
7.
Go to steps 11 through 25 of the “Registering for the first time” programming.
Conditions
• You can assign an extension number to each PS also in programme, [671] PS Extension
Number Set.
• The PS password can be assigned in programme [672] PS Password Set.
• One PS must have only one registration number. It is not possible to assign the different
registration number for one PS.
• If the PS extension number or the PS password is changed after registering, the PS cannot
be used until it is registered again in this programme.
• After pressing the AUTO/OK button in step 16, do not press END before you hear a
confirmation tone, or it may not registered correctly.
• To re-assign the PS, which is set the System Lock, to the other DECT system, it is required
to cancel the System Lock first in PS Programming, “DECT System Lock Password Set.”
• Register the PS from a manager DPT connected only to the master cabinet.