Panasonic KX-TDA15 - Page 26

4.3 Programming the Hybrid IP-PBX
26 Getting Started
Assigning the Incoming Trunk Call Destination
5.
a. Under Configuration, click Slot.
b. Move the mouse pointer over the BRI card,
then click INS to set the card to in-service
status.
For analogue trunk users (DIL Setting):
1. Under CO & Incoming Call, click DIL Table &
Port Settings.
2. Confirm that the DIL tab is selected.
3. Configure the settings as required.
4. Click OK.
For ISDN trunk users (DDI Setting):
1. Under CO & Incoming Call, click DDI / DID
Table.
2. Configure the settings as required.
3. Click OK.
For ISDN trunk users (MSN Setting):
1. Under CO & Incoming Call, click DIL Table &
Port Settings.
2. Click the DDI / DID / TIE / MSN tab.
3. Set the Distribution Method of the desired
ports to MSN.
4. Click OK.