4.3 Programming the Hybrid IP-PBX
Getting Started 25
Assigning the BRI Setting (Automatic Configuration)
1.
a. Under Configuration, click Slot.
b. Move the mouse pointer over the BRI card.
A menu will be shown under the mouse
pointer.
c. Click Ous to set the card to out-of-service
status.
2. Click Tool → BRI Automatic Configuration
from the menu bar.
3.
a. Click Check to turn on the BRI card.
b. Click OK.
4.
a. Enter the subscriber number for the desired
ports in Subscriber.
b. Click Execute.
Note
Network settings are automatically set.
c. Click Check Box of the desired ports.
d. Click Data Apply.
e. Click Close.
To Next Page
Loading...
