1.15 Optional Device Features
Feature Guide 185
corresponding CLI destination extension. Therefore, the "CLI destination" setting in the System Speed
Dialling Table is used here to specify the target extension that the calling telephone will be recognised as
for Walking COS.
[Programming Example of DIL Table]
"CLI" must be set to Disable, to allow incoming calls to be received by DISA.
[Programming Example of System Speed Dialling Table]
In this example, calls received on trunk 01 are routed to the DISA OGM with floating extension number 501.
If the number of the received call (after modification according to the Caller ID table) is "12341115678", the
call originator is recognised as extension 200, and the Walking COS feature is automatically activated.
System programming is required to enable this feature.
SMDR
The call information for DISA is recorded as the one of the DISA floating extension numbers. (→ 1.22.1
Station Message Detail Recording (SMDR))
Trunk No.
CLI Destination
Day Lunch ... Day Lunch ...
01 Disable Disable ...
501
(DISA)
501
(DISA)
...
: : : ::::
Location Name
Trunk Access +
Telephone Number
CLI Destination
000 J. Smith 912341115678 200
001 : : :
::::
To Next Page
Loading...
