1.15 Optional Device Features
Feature Guide 201
• If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside
party), the call will be received at the original destination. (→ 1.3.1.2 Call Forwarding (FWD))
• The following features cannot be used when a sensor call is received:
– Alternate Receiving—Voice (→ 1.5.3 Intercom Call)
– Hands-free Answerback (→ 1.4.1.4 Hands-free Answerback)
– Consultation Hold/Call Hold (→ 1.12.1 Call Hold)
– Call Transfer (→ 1.11.1 Call Transfer)
– Executive Busy Override (→ 1.7.2 Executive Busy Override)
• Sensor call information is output on SMDR.
Installation Manual References
2.5.1 DPH4 Card (KX-TDA3161)
2.5.2 DPH2 Card (KX-TDA3162)
2.8.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
Programming Manual References
PC Programming Manual
3.7.45 [1-1] Slot—DPH Card Property (KX-TDA30 only)
→ For Sensor (EIO)—Input Signal Decision Time
→ For Sensor (EIO)—Input Signal Detection Reopening Time
3.8.4 [2-3] Timers & Counters—Miscellaneous—External Sensor—Ring Duration
3.8.16 [2-8-3] Ring Tone Patterns—Call from Others—External Sensor—Ring Tone Pattern Plan 1–8
3.11.7 [5-5] External Sensor
PT Programming Manual
None
To Next Page
Loading...
