4.3.4 Configuration of IP Ports
A KX-NT300 series
IP-PT user or KX-NT265 IP-PT (software version 2.00 or later) user can configure the port
number of PTAP, DHCP, and FTP ports. Consult your network administrator to check whether the configuration
of the IP ports is required.
Follow the procedure below to configure the port number of the IP ports.
Note
For details for the KX-NT400, refer to the Operating Instructions of the KX-NT400.
IP Networking Guide 71
4.3.4 Configuration of IP Ports
To Next Page
Loading...
