Panasonic KX-TDE600 - SNMP (Simple Network Management Protocol) System Monitor

PC Programming Manual References
4.5 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone—
Dial—Analog CO Call Duration Start
4.12 [2-7-1] Class of Service—COS Settings—CO & SMDR— Outgoing CO Call Printout (SMDR)
8.2 [6-2] Hotel—Main— SMDR for External Hotel Application 2—Printing Message 1–8
13.1 [11-1] Main
→SMDR
→SMDR Options
→RS-232C— Communication—Baud Rate
→RS-232C— Communication—NL Code
→RS-232C— Communication—Word Length
→RS-232C— Communication—Parity Bit
→RS-232C— Communication—Stop Bit
PT Programming Manual References
[800] RS-232C Parameter—New Line Code
[800] RS-232C Parameter—Baud Rate
[800] RS-232C Parameter—Word Length
[800] RS-232C Parameter
—Parity Bit
[800] RS-232C Parameter—Stop Bit Length
[802] SMDR Page Length
[803] SMDR Skip Perforation
[804] SMDR Outgoing Call Printing
[805] SMDR Incoming Call Printing
Feature Manual References
3.1.11 Call Transfer
3.1.23 COS (Class of Service)
4.1.6 DID (Direct Inward Dialing)
4.1.8 DISA (Direct Inward System Access)
8.1.5 Host PBX Access Code (Access Code to the Telephone Company from a Host PBX)
9.1.3 ICD Group Features—Log-in/Log-out
13.1.15 PRIVATE NETWORK FEATURES
21.1 Capacity of System Resources
16.1.5 SNMP (Simple Network Management Protocol) System
Monitor
Description
It is possible for a PC assigned as an SNMP manager to manage and receive PBX system status information,
such as alarm information and general system activity using SNMP. Management Information Bases (MIBs)
are sent to a PC (i.e., the SNMP manager) connected to the PBX over a LAN and can then be stored and
analyzed using SNMP manager software.
The two features for managing information using SNMP are as follows:
– Polling:
Document Version 2013-05 Feature Manual 319
16.1.5 SNMP (Simple Network Management Protocol) System Monitor