4 OPERATING INSTRUCTIONS
4.1. Battery
4.1.1. Battery Installation
4.1.2. Battery Charge
Place the handset on the base unit or charger for about 7 hours before initial use.
When charging, the battery icon is shown as follows. When the batteries are fully charged,
remains on the display.
Note:
• It is normal for the handset to feel warm during charging.
• It takes 7 hours to fully charge the batteries, however, you can use the handset before the batteries are fully charged.
• Clean the charge contacts of the handset and base unit with a soft, dry cloth, otherwise the batteries may not charge
properly. Clean if the unit is exposed to grease, dust or high humidity.
• When
flashes, recharge the handset batteries. will continue to flash until the batteries have been charged for at
least 15 minutes.
• If the handset is turned off, it will be turned on automatically when it is placed on the base unit.
• The handset display may show “Please Wait...” when the handset is placed on the charger if it is not registered to a base
unit.
6
KX-TG1233BXS / KX-TG1233BXT / KX-TCA122CXS / KX-TCA122CXT / KX-TCA121CXS / KX-TCA121CXT
To Next Page
Loading...
