Preparation
21
Programmable Settings
Base unit ringer tone
(use either the handset or the base unit)
Make sure the base unit is not being used.
Setting the base unit ringer tone by using the
Press VOLUME [<] or [>], then select the desired ringer tone by pressing
[1] to [7].
[1] to [3] : Bell ringer patterns [4] to [7] : Melody patterns
• After pressing VOLUME [
<] or [>], the base unit will ring using the current ringer
tone.
• The base unit will ring and the ringer tone will change.
• To stop ringing, press [STOP].
1 Press [MENU].
2 Scroll to “Initial setting” by pressing [
d
] or [
B
], then press
Select.
3 Scroll to “Set base unit” by pressing [
d
] or [
B
], then press Select.
4 Press Select at “Ringer tone”.
5 Select the desired ringer tone by pressing [
d
] or [
B
].
• The base unit will ring and the ringer tone will change. If the base unit ringer
volume has been turned off, the base unit will not ring (p. 19).
• You can also select the ringer tone by pressing [1] to [7].
6 Press Save, then press [OFF].
Base Unit
Handset
PQQX14031ZA.book 21 ページ ２００４年６月２１日 月曜日 午後３時４４分
To Next Page
Loading...
