50
Transferring a Call
You can transfer an outside call to the base unit or the handset.
From the to the
From the to the
• When the base unit user calls all handsets, only the handset user who answers
first can take the transferred call.
1 Handset:
(1)
During a call, press
[HOLD/INTERCOM]
.
• The call is put on hold.
(2) Press Base.
(3) Wait for the paged party to answer, then
you can announce the transfer.
• After the paged party answers, “Intercom
hold” is displayed.
• If the paged party does not answer, press [C]
or [s] to return to the outside call.
2 Base unit:
Press [SP-PHONE] or [LOCATOR/INTERCOM] to answer the page.
3 Handset: To complete the transfer, press [OFF].
1 Base unit:
(1)
During a call, press
[LOCATOR/INTERCOM]
.
• The call is put on hold.
(2) To page a specified handset, press its extension number [1] () or
[2] ().
To page all handsets, press [0].
After the handset user answers, announce the transfer.
OR
To make a voice announcement to all handsets, press [3] ( ),
then speak into the MIC when the SP-PHONE indicator stops
flashing.
• If the paged party does not answer, press [LOCATOR/INTERCOM] to
return to the outside call.
2 Handset:
Press [C], [s] or [HOLD/INTERCOM] to answer the page.
• You can also answer a call by pressing any buttons except [
d
], [
B
] or [OFF].
3 Base unit: To complete the transfer, press [SP-PHONE].
Handset Base Unit
Line on hold.
Transfer to
Base Handset
K
L
Hold
Calling Base
Base Unit Handset
PAGE
PQQX14031ZA.book 50 ページ ２００４年６月２１日 月曜日 午後３時４４分
To Next Page
Loading...
