Programmable Settings
20
Ringer Tone
You can set the handset and base unit ringers to use one of 7 ringer patterns for
outside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4”
are melody patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you subscribe to a Distinctive Ring Service from your telephone company with 2
or 3 consecutive rings, select a bell ringer pattern (Tone 1 to 3). If you select a
melody pattern, you will not be able to distinguish lines by their ringers.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— another person answers the call using another phone connected on the same
line.
Handset ringer tone
1 Press [MENU].
2 Scroll to “Ringer setting” by pressing [
d
]
or [
B
], then press Select.
3 Scroll to “Ringer tone” by pressing [
d
] or
[
B
], then press Select.
4 Select the desired ringer tone by pressing [
d
]
or [
B
].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring (p. 18).
• You can also select the ringer tone by pressing [1]
to [7].
5 Press Save, then press [OFF].
Handset
Ringer setting
Back Select
K
d
BL
Ringer tone
Back Select
K
d
BL
Ringer tone
1:Tone 1
Back Save
K
d
BL
PQQX14031ZA.book 20 ページ ２００４年６月２１日 月曜日 午後３時４４分
To Next Page
Loading...
