Panasonic KX-TG2357C - Page 83

83
Troubleshooting
Useful Information
General
Problem Cause & Remedy
The handset and/or base unit
does not work.
• Check the settings (p. 9–11).
• Check whether the dialing mode setting is
correct (p. 16).
• Fully charge the battery (p. 10).
• Clean the charge contacts and charge again
(p. 11).
• Check battery installation (p. 10).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• Re-install the battery (p. 10) and fully charge
it.
“Recharge battery” is
displayed, “7” flashes, or
the handset beeps
intermittently.
• Fully charge the battery (p. 10).
“Charge for 6h” and “8”
are displayed and the handset
does not work.
• The battery has been discharged. Fully
charge the battery (p. 10).
• Check battery installation (p. 10).
You charged the battery fully,
but “Recharge battery” is
still displayed and/or “7”
continues to flash, or “Charge
for 6h” and “8” are
displayed.
• Clean the charge contacts and charge again
(p. 11).
• The battery may need to be replaced. If you
install a new battery, fully charge it (p. 10).
The CHARGE indicator does
not go out after the battery has
been charged.
• This is normal.
PQQX14031ZA.book 83 ページ ２００４年６月２１日 月曜日 午後３時４４分