Settings
14
Selecting the Line Mode
If the line is connected to a low voltage system such as a PBX, set to “B”.
Otherwise the Call Waiting Caller ID Feature may not be used (p. 54).
Your phone comes from the factory set to “A”.
Use the handset near the base unit.
Make sure the unit is in the standby mode initially.
1
Press (FUNCTION/EXIT/CH).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”.
3
Press FWD/EDIT á (Yes key).
4
Press Ö or Ñ repeatedly until the arrow
points to “Set line mode”.
5
Press FWD/EDIT á (Yes key).
6
Press Ö or Ñ to select “B” or “A”.
7
Press FWD/EDIT á (Save key).
•A beep sounds.
•To return to the standby mode, press
(FUNCTION/EXIT/CH).
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
•If the handset has lost communication with the base unit, 3 beeps sound and “No
link to base. Place on cradle and try again.” is displayed.
H
Set line mode
Set dial mode
GF H
=Yes
Line mode
:A
GF H
=Save
Line mode
:B
H
Save directory
Ringer volume
GF H
=Yes
H
Program
GF H
=Yes
H
Save DIRECT#
Set flash time
GF H
=Yes
Line mode
:B
GF H
=Save
To Next Page
Loading...
