38
Using the Caller List
Storing Caller List Information in the Directory
You can store names and phone numbers that are in the Caller List into
the directory. Storing must be carried out with the handset.
Make sure the unit is in the standby mode initially.
1
Press Ö or Ñ to enter the Caller List.
2
Press Ö or Ñ repeatedly to find the
caller you want to store in the directory,
and press FWD/EDIT á (Yes key).
•If the number requires editing, see page 36.
3
Press Ö or Ñ to select “Save
directory”, and press FWD/EDIT á
(Yes key).
If there is no name information for the
caller, “Enter name” will be
displayed.
a) If a name is not required, press Ö
(Next key) and press FWD/EDIT á.
b) If a name is required, enter the name
(p. 45). When finished, press Ö
(Next key) and press FWD/EDIT á
(Save key).
•A beep sounds.
•
To continue storing other items, repeat from
step 2.
•To return to the standby mode, press
(FUNCTION/EXIT/CH).
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
•If the display shows “Directory full” in step 3, press (FUNCTION/EXIT/CH)
to exit the list. To erase other stored items from the directory, see page 51.
•You cannot store caller information in the directory if a phone number is not
displayed.
•If 3 beeps sound and the display shows “Save error”, move closer to the base
unit and start again from step 1.
CINDY TURNER
1-234-456-7890
11:20A JAN.12
✕
3
10 new calls
GF H
=Directory
H
Edit
Save directory
GF H
=Yes
Edit
H
Save directory
GF H
=Yes
Enter name
IH G
=Next
Enter name
CINDY TURNER
IH G
=Next
CINDY TURNER
1234567890
F
=Edit
H
=Save
To Next Page
Loading...
