One-Touch Dialer
41
Cordless Telephone
You can store a phone number in the (DIRECT) button of the handset. The
stored number is dialed with a one-touch operation.
Storing a Phone Number in the DIRECT Button
Make sure the unit is in the standby mode initially.
1
Press (FUNCTION/EXIT/CH).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”.
3
Press FWD/EDIT á (Yes key).
4
While the arrow points to “Save
DIRECT#”, press
FWD/EDIT á (Yes key).
5
Enter a phone number, up to 48 digits.
•Each time you press (INTERCOM/CLEAR) the
digit to the left of the cursor is erased. To erase
all digits, press and hold (INTERCOM/CLEAR).
•The last 32 digits number you entered will be
displayed. To confirm the remaining number, press
BACK Ü or FWD/EDIT á.
6
Press Ö (Next key).
•If you want to edit the entered number, press
Ñ (Edit key) and return to step 5.
7
Press FWD/EDIT á (Save key).
•A beep sounds.
•To return to the standby mode, press
(FUNCTION/EXIT/CH).
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
•If a pause is required for dialing, (REDIAL/PAUSE) can be stored in a phone
number in step 5. This counts as one digit (p. 54).
IH G
=Next
1234567890123456
7890123456789012
F
=Edit
H
=Save
1234567890123456
7890123456789012
Save DIRECT#
H
Program
Calling pager
GF H
=Yes
H
Save DIRECT#
Set flash time
GF H
=Yes
1234567890123456
7890123456789012
IH G
=Next
To Next Page
Loading...
